Solar Submersible Pump Acrosun Belenus 2.5H.70M-16 ACROSUN - 1

Solar Submersible Pump Acrosun Belenus 2.5H.70M-16 ACROSUN - 2

Solar Submersible Pump Acrosun Belenus 2.5H.70M-16 ACROSUN - 3

Submersible Solar Pump Acrosun Belenus 2.5H.70M-16

The BELENUS solar pumping system consists of 3 pump models and a controller. The pumps operate on direct current, providing higher performance and reliability compared to alternating current pumps. They require fewer solar panels to operate (from 2 units).

This pump is designed for use in low-power pumping systems (up to 3 kW), reaching depths of 140m and flow rates of 15m3/h depending on the selected pump.

It is ideal for new wells without electrical supply or for replacing existing pumps when adding solar panels.

While it can operate without the Acrosun UC250X controller, it allows for the addition of well full probes, and automatic operation, switching between direct current and alternating current from the grid or a generator group.

€1,130.90

Tax included

Uses

These bombs direct current (DC)Thanks to their higher performance and reliability compared to alternating pumps, they are recommended for new wells where there is no electrical supply, as well as for replacing existing pumps in which diesel generators and/or grid power are to be replaced.

They are designed for small pumping tasks, with the most powerful pump in terms of power. P1 2.8kw.

The cost of this pump, including the controller and the panels, It is similar to the cost. From a traditional pump to a frequency inverter, a much higher performance is obtained.

The direct current (DC) solar pumps have a higher performance that alternating pumps with frequency inverters, achieving the same electrical power for the pump up to a 30% more flow on sunny days and up to a 60% more on cloudy days.

They also require... Fewest number of panels Alternating pumps with variable speed drives need to have a high open circuit voltage.

Thank you. Start gradually and smoothly, They have a lower wear and tear on parts compared to regular pumps. Additionally, false starts in the early hours are avoided, as well as delayed stops and starts due to passing clouds. The flow obtained starts from the early hours of the morning, when the pump gradually starts operating until reaching maximum performance during the midday hours.

Description

The bomb is composed of two sections differentiated.

One of them contains the electric motor and the hydraulic components. The motor and pump body are made of stainless steel. AISI 304. It has a 3HP engine. permanent magnets that allows to save energy, as well as centrifugal hydraulic.

In another part of the pump is the electronics section. Inside it, there is aMaximum Power Point Tracking, capable of achieving the optimal performance of the panels. It also incorporates electronics capable of allowing work in both direct current and alternating current, whether from a generator or directly from the grid.

It is not necessary to install Dry well probe, nor its wiring thanks to the pump protection system StopFlow, which includes the dry well level probe integrated inside the pump.

The wiring of three 3 threads: (Earth + Pole 1 + Pole 2)It has no polarity. Designed for easy installation.

The use is very simple thanks to having only access to 3 models of simple bombas being the choice. reaching up to140 meters deepI'm sorry, but your message seems to be incomplete. Could you please provide more context or clarify what you would like to translate from Spanish to English?flow rate of 15m3/hAccording to the selected pump.

For the selection of the pump, you can consult the input table based on the required height and flow rate. Once you have selected from the table, you can determine the necessary power on the panel to reach the requested point on the curve. It is recommended to set on the panel between one. 15-20% input power, due to losses from high temperature and panel degradation.

If you have any doubts, Contact our technical team for the selection of your team.

Accessories

The controller Acrosun UC250X, add additional features to the pumps Belenus. While pumps can operate without a controller, they do add a series of additional features.

I'm sorry, but it seems like your message is incomplete. Could you please provide more context or repeat your request? Font selection power input. It can operate solely with photovoltaic, with alternating current from a generator or the grid, and in automatic mode.

• Control of full tank pump.

• Surge protection on AC-DC.